Customizable ESP32 lateral support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I had wanted to have access to boot, reset buttons and pins at the same time. So I decide to make lateral support.…
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 249
- Wydruki
- 0
- Wyświetlenia
- 1000
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I had wanted to have access to boot, reset buttons and pins at the same time.
So I decide to make lateral support.
Since there is no much space for screws, there are pins (only in openScad version) that since they are very small, they will not print very well.
There is an option by default to use clips.
In OpenSCAD and FreeCAD file, you can modify the parameters, There are lots of variants of these development kits, so measure yours, enter the values in the dimensions spread sheet and export to stl.
| description | parameter | default value | ESP32-S2-Saola-1 | ESP32-S2-DevKitM-1 | ESP32-S2-DevKitC-1 |
|---|---|---|---|---|---|
| Esp32 board dimensions | esp32XLength | 55.8 | 53.9 | 54 | 62.74 |
| esp32YLength | 28 | 27.9 | 25.4 | 25.4 | |
| esp32Thick | 2 | ||||
| Esp32 board hole placement | esp32HoleDia | 2 | |||
| esp32XHoleCenterDst | 51 | ||||
| esp32YHoleCenterDst | 24 | ||||
| Esp32 base dimensions | esp32BaseXLength | 70 | |||
| esp32BaseYLength | 30 | ||||
| esp32BaseThick | 2 | ||||
| esp32BasePinHeight | 2 | ||||
| esp32BasePinOverLap | 0.3 | ||||
| Esp32 clip dimensions | esp32BaseClipHeight | 2 | |||
| esp32BaseClipLength | 8 | ||||
| esp32BaseClipOverLap | 0.5 | ||||
| Esp32 window hole for pin rows | esp32PinRowXLength | 51 | |||
| esp32PinRowYLength | 8 | ||||
| Floor base | baseZLength | 15 | |||
| baseXHoleCenterDst | 62 | ||||
| baseZHoleCenterDst | 3 | ||||
| baseHoleDia | 3.5 |
Category: Electronics
Revisions
01.08.2023
- Made a FreeCad file without pins
- Modified BaseZhole calculation in SCAD file
- Made a documents with corresponding parametric dimensions