1 / 3
Voron V0.2R1 Klipper Expander Rear Skirt — zdjęcie 1
1 / 3

Voron V0.2R1 Klipper Expander Rear Skirt

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A place to put your Klipper Expander

Ocena
5 / 5
Polubienia
20
Pobrania
73
Wydruki
1
Wyświetlenia
901
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

INTRODUCING THE KLIPPER EXANDER RAER SKIRT FOR THE V0.2R1

after seeing and printing out RichardTHF's Klipper Expander mount / skirt (found here)
https://www.printables.com/model/508445-klipper-expander-mount-for-v02-and-v02-r1-rear-ski/comments
it was exactly what i needed to reduce the clutter in my electronics area.
the only thing i personally didn't like was it was a bit bulky and had multiple parts to print.
my goal was to keep printed parts to a minimum and keep the design as simple as possible.

i started from the ground up with this design but i will still give credit to @RichardTHF as he first published the idea, so please feel free to check out his model.
i just used his idea to come up with a more simplistic version with minimal modification to the original skirt design.

the extra hardware required are

2 x heat set nuts

2 x M3x6 button heads

these are for mounting the expander board to the skirt… and thats it!

it has cut outs at the top to push through the wires to the terminals and i have left nearly all the hex openings open to allow other sensors / other wiring to have access to the bottom part of the board.

if you have any feedback on this design please feel free as it all helps make a better print.

NOTE, the download has been updated as it was not placing the model on the V0 bed properly. it should now be fixed and place it at 45 Degrees.

happy printing and dont forget to post your make of this!

REGULAR V0.2 SKIRT VERSION COMMING SOON!
 

Tagi