1 / 4
Land Rover Series PTO Trailer Socket
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Most Land Rovers don't come with PTOs anymore, which leaves the PTO hole open for a 13 pin trailer socket.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 486
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (15)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (7)Powiązane
Versions
- With Support: These models have a little support material added and a bridge for the mounting holes, which makes it possible to print the model entirely without additional supports.
- With Cutout: Our PTO hole (replacement frame part from Britpart) had quite a thick weld bead for which I added a cutout in the model. Your frame may vary, so you can use the model without cutout. Furthermore, you can use the “Cutout Piece” to place a negative volume in PrusaSlicer and create a cutout in your desired spot. The model has the cutout at ~18° relative to the horizontal axis.
Recommended Material & Print Settings
- The print in the pictures was made with ABS, in a car it's best to use ABS, PETG, ASA, …
- Use high infill in the tabs for a strong part. The disc part can have less infill.
- 3 perimeters recommended
Additional Hardware
- Trailer Socket Herth+Buss 51305036 (or equivalent, most 13-pin sockets share the same bolt pattern)
- 3x M6 hex key bolts and nuts (length depends on your specific socket)
- 3x screws for mounting the adapter plate to the frame (self tappers, rivnuts, tapping directly into the frame, …)
Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament and O-rings to get this right.