Case collator/feeder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Complex model, gcode not included, as modifications according to your application are assumed.
- Ocena
- 4,667 / 5
- Polubienia
- 96
- Pobrania
- 966
- Wydruki
- 4
- Wyświetlenia
- 6435
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Please pay attention to a new version of this model, published here: https://www.printables.com/model/1044261-case-feedercollator-update .
Complex model, gcode not included, as modifications according to your application are assumed.
Notes and other major components sample references:
- Motor mount designed for JGA25-370 Geared motor DC motor 12V 5rpm ( https://www.aliexpress.com/item/32987942205.html )
- Bullet drop adapter designed for:
- proximity sensor LJ12A3-4-Z/BY ( https://www.aliexpress.com/item/32859197984.html ). Model assumes thread cutting instead of printing for better accuracy. Sensor purpose is bullet counting. Cut the thread by 12mm tap, note the pitch (fine pitch 1,5mm).
-Mr.Bulletfeeder output spring Large for pistol calibers ( https://www.doublealpha.biz/mrbulletfeeder-output-spring-and-extension-adaptor ).
- Case bucket dimension is too small for rifle cases.
I recommend to use wooden anchor pin to prevent motor gear or feeder parts damage in case something goes wrong, at least during the setup phase.
Tribute to https://github.com/dyspreficks/ShoeboxCaseFeeder .
Print instructions
For Anchor_case, Bucket_stand, Upper_end1_case and Upper_end2_case PLA recommended.
Other parts PLA and/or PETG according to your preferences. Except Anchor part, no supports are required.
For large parts - eg. bucket etc., 0,2mm layer is OK.
For Anchor, brim and support on build plate are required.
Drop_tube - remove the stabilizing "skirt" after print!