Case collator/feeder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Complex model, gcode not included, as modifications according to your application are assumed.
- Rating
- 4.667 / 5
- Likes
- 96
- Downloads
- 966
- Makes
- 4
- Views
- 6,435
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Please pay attention to a new version of this model, published here: https://www.printables.com/model/1044261-case-feedercollator-update .
Complex model, gcode not included, as modifications according to your application are assumed.
Notes and other major components sample references:
- Motor mount designed for JGA25-370 Geared motor DC motor 12V 5rpm ( https://www.aliexpress.com/item/32987942205.html )
- Bullet drop adapter designed for:
- proximity sensor LJ12A3-4-Z/BY ( https://www.aliexpress.com/item/32859197984.html ). Model assumes thread cutting instead of printing for better accuracy. Sensor purpose is bullet counting. Cut the thread by 12mm tap, note the pitch (fine pitch 1,5mm).
-Mr.Bulletfeeder output spring Large for pistol calibers ( https://www.doublealpha.biz/mrbulletfeeder-output-spring-and-extension-adaptor ).
- Case bucket dimension is too small for rifle cases.
I recommend to use wooden anchor pin to prevent motor gear or feeder parts damage in case something goes wrong, at least during the setup phase.
Tribute to https://github.com/dyspreficks/ShoeboxCaseFeeder .
Print instructions
For Anchor_case, Bucket_stand, Upper_end1_case and Upper_end2_case PLA recommended.
Other parts PLA and/or PETG according to your preferences. Except Anchor part, no supports are required.
For large parts - eg. bucket etc., 0,2mm layer is OK.
For Anchor, brim and support on build plate are required.
Drop_tube - remove the stabilizing "skirt" after print!