1 / 1
Camlock Connector adapter to fit a 40mm hose to a stock Hose Fitting
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An accessory for the Camlock Connectors with Magnetic Catch by @PeterH, remixed using his STEP files.
- Ocena
- 5 / 5
- Polubienia
- 101
- Pobrania
- 686
- Wydruki
- 10
- Wyświetlenia
- 2804
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 10) (Komentarze: 10)Remiksy (1)Kolekcje (186)Powiązane
Made to fit a 40mm vacuum hose to an unmodified Hose Fitting from @PeterH's “Camlock Connectors with Magnetic Catch”. At the fitting side it screws in easily, at the hose side it is a bit more snug. If it is too snug, use the Offset Face feature in Fusion 360 on the inside of the thread/coil. STEP file is found below.
Note that these hoses have a reversed thread so you have to turn them the “wrong” way.