1 / 4
X-Shot Longshot Magwell Hardstop Strengthener for RedCowl's Magwells — zdjęcie 1
1 / 4

X-Shot Longshot Magwell Hardstop Strengthener for RedCowl's Magwells

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Hard-Stop Strengthener for RedCowl's Half Dart Magwells, for the times you LARP too hard.

Ocena
5 / 5
Polubienia
30
Pobrania
175
Wydruki
2
Wyświetlenia
1680
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Outdoor Toys
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

MAGWELLS FOUND HERE: https://www.printables.com/model/512021-xshot-longshot-half-dart-magwells 

I apparently LARPed too hard when reloading my Lonxshot with RedCowl's more flush magwell installed, and managed to shear off both hard-stops that prevent Talon magazines from being over-inserted into the blaster. 

Well, instead of just not being as rough, I decided to take a few days to design this. After a few iterations, here it is; something that should hopefully allow me to slap mags into the magwell as hard as I want. This piece needs to be glued to RedCowl's magwell and rests against the blaster shell's plastic, hopefully meaning the 3d printed stuff doesn't take all the force from tacticool reloads.

Assembly

Just glue it onto the top of your RedCowl Half Dart Magwell as shown in the pictures.

Print Instructions

Print this piece with the side with the curve near the rear of the magwell facing down towards the build plate.

 

NONE of my files are to be used or sold by Frontline Foam, by downloading my files, you agree that you are not Frontline Foam and/or related to Frontline Foam or Derrikk Sun.

Tagi