Casio 3502 NATO Strap Adaptor (18mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a small adaptor bracket for the Casio 3502 to allow use of an 18mm wide NATO strap, which can't be done stock.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 879
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- GNU General Public License v2.0
Hello!
This model will allow you to use an 18mm NATO strap of your choice with your Casio 3502 watch. While it does stick out from your wrist more, I find it to be much more comfortable than the stock strap.
Installation Instructions:
1) Remove the original straps using a pin removal tool.
2) Remove the 4 screws from the back of the watch.
3) Remove all supports from the model carefully. A metal spudger is an ideal tool for this.
4) Run the strap through the back of the adaptor. You will be able to guide it through with a small screwdriver to help push it through, as the back is open.
5) Mount the bracket to the rear plate of the watch. Take the 4 original screws and run them through the mounting holes. (You may need to widen the holes slightly before the screws take)
6) ???
7) Profit!
I will try and make some tweaks to the model in the future to improve the mounting holes and increase strength.
Print Recommendations:
Print the model with the gap facing down, supports everywhere. Line supports are fine.
I recommend printing slowly unless you have a fancy printer like a Bambu. I printed this in PETG on my heavily modified Ender 3 V2 at 25mm/s.