Screwless suspended undershelf wine glasses hook

I remixed the remix with the following modifications:

• The model is now 129x173mm
• It is now 16mm thick, to hold my choncky glasses
• I made an extension to make the rail longer
• I made a guide gig to help align the extension
• I made four slots to fit 3M Command strips 70mmx19mm (the “L” size).  I have tested this setup with my heavy glasses and they hold strong. Might have worked with fewer strips too, but better safe than sorry.

Printing instructions:

• Print flat, as uploaded. No need for supports
• 0.6 nozzle recommended
• 0.3mm layer height is probably good, I printed 0.26mm just for a better look
• PLA works great

Fitting instructions:

• Cut away the pull lip of the Command strips. They will sit embossed in the slot.
• I recommend attaching the Command strip to the holder with superglue.
• Wait for the glue to dry then attach the matching Command strip
• Apply to the designated surface. Hold in place for 30 seconds.
• I recommend waiting 2 hours before loading with glasses (although I only waited 30 mins and it's working fine)
• If you're adding the extension, use the provided alignment gig to properly distance the two sides