Bestway Pool Outlet Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Bestway inlet/outlet cap that seals off the pool and allows you to replace the filter without water escaping.
- Ocena
- 5 / 5
- Polubienia
- 58
- Pobrania
- 462
- Wydruki
- 4
- Wyświetlenia
- 1760
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This cap is designed to fit the Bestway P61322 Pool Outlet Strainer - 32mm.
Can be fitted with a rubber O-Ring (80mm OD, 74mm ID, 3mm Width )
Print flat side down. 0.2mm layer height and 20% infill works well. No supports required.
Using PLA is fine they are kept in the shed most of the time and only come out once a week.
Caution, running the pump with these fitted to the inlet/outlet may cause damage to the motor. The filament used in the images was Creality Ender PLA+ Orange so I could easily identify if they had been left on before starting the pump.