Bestway Pool Outlet Cap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Bestway inlet/outlet cap that seals off the pool and allows you to replace the filter without water escaping.
- Rating
- 5 / 5
- Likes
- 58
- Downloads
- 462
- Makes
- 4
- Views
- 1,760
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This cap is designed to fit the Bestway P61322 Pool Outlet Strainer - 32mm.
Can be fitted with a rubber O-Ring (80mm OD, 74mm ID, 3mm Width )
Print flat side down. 0.2mm layer height and 20% infill works well. No supports required.
Using PLA is fine they are kept in the shed most of the time and only come out once a week.
Caution, running the pump with these fitted to the inlet/outlet may cause damage to the motor. The filament used in the images was Creality Ender PLA+ Orange so I could easily identify if they had been left on before starting the pump.