Voron V2.4 Frame Stabilisers UPDATED
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A frame stabiliser with a small form factor to fit nicely in your V2.4
- Ocena
- 0 / 5
- Polubienia
- 39
- Pobrania
- 184
- Wydruki
- 0
- Wyświetlenia
- 1246
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of my frame stabiliser for the Voron V0 now made to fit the Voron 2.4 frame size.
I have beefed it up to add extra rigidity as the frame size is much larger than the V0.
But still keeps a small form factor to sit neatly in the corners of your frame.
This is now availible in two sizes…
V1 = 97mm long (original)
V2 = 124mm long (new)
Print with the usual Voron Settings for best results
4 x perimeter
5 top and bottom
40% infill
ABS / ASA is recommended if printing in an enclosure
After some feedback i have made the fixing holes a little larger as they were a bit on the snug side
Any feedback on this design will be very welcome!
As always, happy printing and don't forget to upload your make!