1 / 5
BambuMute Muffler Remix for 5x5x4 Magnets — zdjęcie 1
1 / 5

BambuMute Muffler Remix for 5x5x4 Magnets

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of the amazing "BambuMute - The ultimate overengineered muffler for your BambuLab" for lots of 5x5x4 or 5x5x2

Ocena
0 / 5
Polubienia
13
Pobrania
60
Wydruki
0
Wyświetlenia
1034
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I really love the design of the muffler from @Peter_476879 but unfortunately I didn't have the right magnets for it. So I had to decide a) buy another pack of magnets or b) use what i have (5x5x2) and learn how to use Tinkercad…

In the end my wife decided for me that online shopping again is not an option  0.0

And this is the result. My re-design has 7 holes for two 5x5x2 magnets each (or one 5x5x4) to make sure it always stays where you placed it because it is heavy. You don't have to use all the holes - but you can! And I wanted the magnets to stick out a little bit - because I also redesigned the rubber seal. It now has fitting holes for the magnets.

Print the muffler in PLA or PETG of your choice with 0,16mm layer height (or less if you have enough time and patience) and the rubber seal in TPU.

You will need:

  • up to 14 magnets 5x5x2 (N52 highly recommended) or 7 magnets 5x5x4
  • Glue for the magnets and for the rubber seal. I used hot glue for the magnets and superglue for the rubber seal 

Happy printing! 

Tagi