Silicone Sock for Zmorph FAB Dual Pro toolhead
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mould to create a silicone sock for a Zmorph Fab toolhead.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 159
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I created this mould for my Zmorph FAB dual mixer toolhead.
I printed it on an Elegoo Saturn resin printer with 50um layer height. I used 2-part TFC Silikon Kautschuk Typ 3 high temperature silicon for ease of release. Printed with Siraya Tech Build resin.
I created the following remix for a nozzle to fit this mould. To use, mix the two part resin, draw into a syringe the pump into mould vertically and continue until the silicon is visible from the 3 exit holes. Wait for it to set the remove from the mould and cut out the nozzle circle. When fitting on the Zmorph toolhead, seat around the brass nozzle.
https://www.printables.com/model/537733-luer-lock-nozzle
I used a resin printer so layer lines would not be visible. It should also work with an FDM printer, but better with a small nozzle diameter.
To separate model place a plastic spludger between the base and top where the taper is an slowly work around the mould until it releases.