Silicone Sock for Zmorph FAB Dual Pro toolhead
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A mould to create a silicone sock for a Zmorph Fab toolhead.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 159
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
I created this mould for my Zmorph FAB dual mixer toolhead.
I printed it on an Elegoo Saturn resin printer with 50um layer height. I used 2-part TFC Silikon Kautschuk Typ 3 high temperature silicon for ease of release. Printed with Siraya Tech Build resin.
I created the following remix for a nozzle to fit this mould. To use, mix the two part resin, draw into a syringe the pump into mould vertically and continue until the silicon is visible from the 3 exit holes. Wait for it to set the remove from the mould and cut out the nozzle circle. When fitting on the Zmorph toolhead, seat around the brass nozzle.
https://www.printables.com/model/537733-luer-lock-nozzle
I used a resin printer so layer lines would not be visible. It should also work with an FDM printer, but better with a small nozzle diameter.
To separate model place a plastic spludger between the base and top where the taper is an slowly work around the mould until it releases.