Phrozen Sonic Mini 8k Heater Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalistic heater mount for 100W PTC in a Phrozen Sonic Mini 8k
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 516
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Minimalistic model to hold the ubiquitous 100W PTC heater with fans used to keep resin printer enclosures heated. Designed to hold heater using 2 M4x60mm hex standoffs. Needs two M4 flat head screws on bottom and two pan head screws on the top to assemble. A 0.25-inchØ x 0.25-inch magnet is installed to hold the mount in position but allow quick removal when needed. Need to file a hole in rear of enclosure for wires to pass. Mount has features for wire tie to secure wires in place to mount.
I've run it at 35°C without any problems. Printed in PLA+ 0.3mm layer height.
https://www.amazon.com/Mecion-Female-Standoff-Hexagon-Threaded/dp/B088FJXWR2
https://www.amazon.com/gp/product/B0BNZQFWHN
https://www.amazon.com/gp/product/B0BHY57L7D/