Phrozen Sonic Mini 8k Heater Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Minimalistic heater mount for 100W PTC in a Phrozen Sonic Mini 8k
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 25
- Makes
- 0
- Views
- 516
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Minimalistic model to hold the ubiquitous 100W PTC heater with fans used to keep resin printer enclosures heated. Designed to hold heater using 2 M4x60mm hex standoffs. Needs two M4 flat head screws on bottom and two pan head screws on the top to assemble. A 0.25-inchØ x 0.25-inch magnet is installed to hold the mount in position but allow quick removal when needed. Need to file a hole in rear of enclosure for wires to pass. Mount has features for wire tie to secure wires in place to mount.
I've run it at 35°C without any problems. Printed in PLA+ 0.3mm layer height.
https://www.amazon.com/Mecion-Female-Standoff-Hexagon-Threaded/dp/B088FJXWR2
https://www.amazon.com/gp/product/B0BNZQFWHN
https://www.amazon.com/gp/product/B0BHY57L7D/