1 / 1
Voron 2.4 5015 Bed Fan (Purge Bucket + No Z-Endstop) — zdjęcie 1

Voron 2.4 5015 Bed Fan (Purge Bucket + No Z-Endstop)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A mounting panel which supports a Sunon 5015 blower fan to circulate air under the bed for improved chamber heating.

Ocena
5 / 5
Polubienia
11
Pobrania
50
Wydruki
1
Wyświetlenia
1276
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This remix of Ślimak's original provides an option for those folks running a purge bucket without a z-endstop (in my case because I'm running Voron Tap). It also addresses the problem of being unable to remove your purge bucket when this is fitted (by removing the left hand side of the original and re-working the airflow to compensate).

Bill of Materials

You'll need the following to assemble this:

  • 5015 blower fan (Sunon/Delta etc)
  • 4x M3 T-nuts
  • 4x M3x6 FHCS

When attaching the fan, you may find it useful to place some 1mm foam tape on the bottom of the fan to reduce vibrations against the bottom panel.

Printing Guidance

This part is designed to be printed using the standard Voron structural parts settings, namely:

  • 0.4mm nozzle
  • 0.2mm layer height
  • 40% infill (grid/cubic/gyroidal/honeycomb)
  • ABS/ASA

Tagi