1 / 4
gosund sp111 aka "Jisusu" aka "TedGem" SmartLife Wifi Plug Flashing Adapter — zdjęcie 1
1 / 4

gosund sp111 aka "Jisusu" aka "TedGem" SmartLife Wifi Plug Flashing Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple pogo pin header tool to reflash those ESPs with Tasmota

Ocena
0 / 5
Polubienia
1
Pobrania
17
Wydruki
0
Wyświetlenia
470
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I liked the general design of Rhazgular's Flashtool from Thingiverse but did not intend to integrate a complete FTDI assembly into it and use a pin header instead.

So I decided the original design was a bit too much for me and cut down the volume and printing time. I also added an old micro switch for easy flashing initialisation. Last but not least i widened the pogo pin holes a bit to make mounting the pins easier for me and cut away parts of the body where it could interfere with the WLan antenna.

I recommend soldering the pins to the wires before inserting them to prevent unwanted melting effects. When the pogo pins are aligned correctly, add a drop of CA on their base to fix them permanently The pin header and microswitch were attached with a glob of hot glue.

 

Print Settings


Rafts: No
Supports: No
Resolution: 0.1mm
Infill: 15%
Filament: filamentum PLA natural 
 

Notes: 

I recommend taking the time to print in 0.1 and not too fast to get the small pogo pin holes printed precisely.

 

 

 

Tagi