1 / 4
gosund sp111 aka "Jisusu" aka "TedGem" SmartLife Wifi Plug Flashing Adapter — image 1
1 / 4

gosund sp111 aka "Jisusu" aka "TedGem" SmartLife Wifi Plug Flashing Adapter

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple pogo pin header tool to reflash those ESPs with Tasmota

Rating
0 / 5
Likes
1
Downloads
17
Makes
0
Views
463
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

I liked the general design of Rhazgular's Flashtool from Thingiverse but did not intend to integrate a complete FTDI assembly into it and use a pin header instead.

So I decided the original design was a bit too much for me and cut down the volume and printing time. I also added an old micro switch for easy flashing initialisation. Last but not least i widened the pogo pin holes a bit to make mounting the pins easier for me and cut away parts of the body where it could interfere with the WLan antenna.

I recommend soldering the pins to the wires before inserting them to prevent unwanted melting effects. When the pogo pins are aligned correctly, add a drop of CA on their base to fix them permanently The pin header and microswitch were attached with a glob of hot glue.

 

Print Settings


Rafts: No
Supports: No
Resolution: 0.1mm
Infill: 15%
Filament: filamentum PLA natural 
 

Notes: 

I recommend taking the time to print in 0.1 and not too fast to get the small pogo pin holes printed precisely.

 

 

 

Tags