Air Fitting Hanger, Magnetic

This little magnetic hook lets you hang your extra air compressor fittings right on the side of the tank.

Specs:

*Dimensions: 2.000"W x 1.375"D x 1.125"H
*Volume: 0.68 cubic inches
*Weight: ~0.03 pounds

Files:

*Hook for 18.5" diameter tanks: PTW-00-1-PT-0227 (Hanger, Air Fitting, Type D, 18.5in).STL
*Hook for 20" diameter tanks: PTW-00-1-PT-0227 (Hanger, Air Fitting, Type D, 20in).STL

Needed to complete assembly:

• QTY 3-6: 10mm diameter x 2.6mm thick Neodymium Magnets - http://www.dx.com/p/10-x-3mm-ndfeb-neodymium-magnet-circular-cylinder-diy-puzzle-set-silver-50-pcs-229283#.VOqSt9jnQYI (Description says 3mm thick, but are actually 2.6mm)
• Epoxy: For gluing in magnets
• (OPTIONAL) Plasti-Dip spray: Spray on magnets, to give them some friction.
  NOTES:

---

• .STL names do not match .SLDPRT name because Da Vinci will not print file names over 56 characters.
• .STL files oriented for printing.
• Supports are needed to print the part.

Print instructions

Category: Tool Holders & Boxes Summary

This little magnetic hook lets you hang your extra air compressor fittings right on the side of the tank.

Specs:

*Dimensions: 2.000"W x 1.375"D x 1.125"H
*Volume: 0.68 cubic inches
*Weight: ~0.03 pounds

Files:

*Hook for 18.5" diameter tanks: PTW-00-1-PT-0227 (Hanger, Air Fitting, Type D, 18.5in).STL
*Hook for 20" diameter tanks: PTW-00-1-PT-0227 (Hanger, Air Fitting, Type D, 20in).STL

Needed to complete assembly:

• QTY 3-6: 10mm diameter x 2.6mm thick Neodymium Magnets - http://www.dx.com/p/10-x-3mm-ndfeb-neodymium-magnet-circular-cylinder-diy-puzzle-set-silver-50-pcs-229283#.VOqSt9jnQYI (Description says 3mm thick, but are actually 2.6mm)
• Epoxy: For gluing in magnets
• (OPTIONAL) Plasti-Dip spray: Spray on magnets, to give them some friction.
  NOTES:

---

• .STL names do not match .SLDPRT name because Da Vinci will not print file names over 56 characters.
• .STL files oriented for printing.

• Supports are needed to print the part.

  Instructions

  1. Print the part, with supports under the hook, and in the magnet pockets. Print at 100% fill, for strength.
  2. Epoxy in magnets. I found it best to put a plastic shopping bag over each magnet, as I epoxied it, and hold them in place until it sets, to keep them from magnetically jumping to each other. It's easier to have a friend help with this.
  3. (OPTIONAL) Spray a couple coats of Plasti-Dip rubber spray over the magnets, to give them some grip on the air compressor tank.