1 / 3
GD-R14 Aftermarket Garage Remote Control Cover — zdjęcie 1
1 / 3

GD-R14 Aftermarket Garage Remote Control Cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is the snap in cover for the dip switches on this remote.

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
307
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

This cover may fit other openers with this similar case. It does fit tight and may need a little carving and sanding to fit. Since the tabs are an overhang and I did not use supports they bowed down a little. I used a pocketknife to trim the sag away. I used generic PLA at 100% infill. Takes about 15 to 20 minutes to print.

Tagi