1 / 3
GD-R14 Aftermarket Garage Remote Control Cover — image 1
1 / 3

GD-R14 Aftermarket Garage Remote Control Cover

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is the snap in cover for the dip switches on this remote.

Rating
0 / 5
Likes
1
Downloads
18
Makes
0
Views
307
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution

This cover may fit other openers with this similar case. It does fit tight and may need a little carving and sanding to fit. Since the tabs are an overhang and I did not use supports they bowed down a little. I used a pocketknife to trim the sag away. I used generic PLA at 100% infill. Takes about 15 to 20 minutes to print.

Tags