Replacement Lowel 7038 Light Stand Set Knobs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replace those little knobs that tend to back off the studs and get lost.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 234
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These are the SMALL set knobs for the Lowel Omni Stand 01-33 (and apparently Uni TO Stand UN-33 and Uni-stand UN-33), to replace the knob-end of Lowel part number 7038.
If you need the stud, it's kind of an odd bird. You can cut it from 12-24 all-thread, if such can be found. My studs are barely under 7/8in long in total (and they've apparently been ground at the end).
I printed with PETG, 90% infill, .16mm layer, no support. Printed on the back - it's the biggest flat face.
The threaded holes have a couple of perpendicular crossing wells inside, so if you want to affix with epoxy, there's someplace for the epoxy to make a mechanical grab in there (epoxy will only make a mechanical, not a chemical bond with PETG and with the stud). Suggest you affix these with an adhesive - they tend to back off if not.
Be gentle: the screw thread follows the weak axis.