Replacement Lowel 7038 Light Stand Set Knobs
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replace those little knobs that tend to back off the studs and get lost.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 35
- Makes
- 0
- Views
- 234
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These are the SMALL set knobs for the Lowel Omni Stand 01-33 (and apparently Uni TO Stand UN-33 and Uni-stand UN-33), to replace the knob-end of Lowel part number 7038.
If you need the stud, it's kind of an odd bird. You can cut it from 12-24 all-thread, if such can be found. My studs are barely under 7/8in long in total (and they've apparently been ground at the end).
I printed with PETG, 90% infill, .16mm layer, no support. Printed on the back - it's the biggest flat face.
The threaded holes have a couple of perpendicular crossing wells inside, so if you want to affix with epoxy, there's someplace for the epoxy to make a mechanical grab in there (epoxy will only make a mechanical, not a chemical bond with PETG and with the stud). Suggest you affix these with an adhesive - they tend to back off if not.
Be gentle: the screw thread follows the weak axis.