Offset side rail for Sneaks Pi case on Prusa MK4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Customized version of the Prusa MK3 side rail for Sneaks' RPi mount for the Prusa MK4 with provision for cable routing
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 43
- Wydruki
- 2
- Wyświetlenia
- 392
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Mount a Raspberry Pi in Sneaks' awesome deep snap-together case on a Prusa MK4 with it offset to the outside with provision for cable management.
Note: the actual thing in the photos is black and kinda blends into the Prusa frame. Sorry about that.
The Sneaks snap-together Raspberry Pi case is by far my favorite, not just cuz he's a great guy, but it's the best Pi case I've used, especially with the provisions to mount it to the side of Prusa printers.
I got a MK4 and wanted to use the case but discovered that it would work a little better if I shifted the Pi outboard, so modified the original “__ss_rail_1_04-MK3S_DEEP.STL” to shift where it held the RasPi. While I was at it, I added a post which I used to hold the cables coming from the RasPi with a loop of velcro. Posting bt request of @meathead so other Prusa MK4 users can do the same.
Note that this requires the use of the “deep” cases. I used the following files from Sneaks' Pi case:
- __raspi_top_1_06A-SS_4_DEEP.STL
- __raspi_bottom__1_05-SS_4.STL
- __raspi_module_1_01-SNAP-IN FAN.STL
Get those files (or whatever fits your use case) from the original - this is just the offset rail to mount that on the MK4.
Print instructions
Print it pretty much however you want, following Sneaks' original instructions would be a safe bet. Supports are not needed since the cable post should bridge just fine.