1 / 2
JST-XH 2.54 mm spacing hot glue wire mold Parametric — zdjęcie 1
1 / 2

JST-XH 2.54 mm spacing hot glue wire mold Parametric

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

All my hard work crimping and the wire breaks cause I pulled on it. Solved with hotglue. JST XH 4 pin 2.54 MM Spacing.

Ocena
0 / 5
Polubienia
26
Pobrania
98
Wydruki
1
Wyświetlenia
1062
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

I use vegetable oil as a mold release and the PLA works but i can tell it degrades with the heat of the hot glue.

PETG recommended but not required.  No Supports needed.

Fill hole is perfect for a ryobi one+ hot glue gun but should realy work with any.

Fill till it squirts out the other side and clamp well to reduce flashing.

Cable hole is 4-5 mm

Modify it here on onshape: Parametric JST Hot Glue Mold

You can change pin counts and the wire diameter

I included clamps as well which should just slide over the mold and keep it tight
 

Tagi