1 / 2
JST-XH 2.54 mm spacing hot glue wire mold Parametric — image 1
1 / 2

JST-XH 2.54 mm spacing hot glue wire mold Parametric

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

All my hard work crimping and the wire breaks cause I pulled on it. Solved with hotglue. JST XH 4 pin 2.54 MM Spacing.

Rating
0 / 5
Likes
26
Downloads
98
Makes
1
Views
1,064
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

I use vegetable oil as a mold release and the PLA works but i can tell it degrades with the heat of the hot glue.

PETG recommended but not required.  No Supports needed.

Fill hole is perfect for a ryobi one+ hot glue gun but should realy work with any.

Fill till it squirts out the other side and clamp well to reduce flashing.

Cable hole is 4-5 mm

Modify it here on onshape: Parametric JST Hot Glue Mold

You can change pin counts and the wire diameter

I included clamps as well which should just slide over the mold and keep it tight
 

Tags