Replacement cap for insta360 go2 Pivot Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model helps fix a pivot Stand for the insta360 go2 that has borken at its weak point around the screw
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 320
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The problem
The Pivot Stand for the insta360 go2 is one of the best mounts, but mine broke around the screw where the plastic is really thin.
A new pivot stand is cheap, but since the release of the insta360 go3, this one has become impossible to find, so repairing it was my only option
The broken piece has the magnets needed to mount the camera, so this print is a shroud around it which allows you to mount the piece back to the rest of the stand with the original screw
Required materials
- 3d printed part
- sandpaper
- hobby knive to speed thinngs up (optional)
Print settings
General settings: print with 0.2mm layers and 100% infill - it will print as all walls
Supports:
The holes for the mount + screw intersect, so a bit of one layer will be printed mid air.
I have printed this without supports and it still woked because the bridging area is quite small
If you enable supports, the hole goes all the way through so you will be able to push the supports out the other side at the end. However
Installation
You will need to sand the broken piece down so it is fully round. I used a hobby knife to cut off the big parts (be prepared to throw away the blade after this)
Once the broken piece is sanded smooth, it should friction fit inside the printed shroud which then attaches back onto the base with the original screw.