Wall Mount for Anker 727 Charging Station
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple mounting bracket for the Anker 727 Charging Station
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 111
- Wydruki
- 1
- Wyświetlenia
- 503
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update 2025-11-03: The original PETG version failed after 2+ years, predictably breaking at the short tabs. I adjusted the design to print in a relatively hard TPU (68D) with a tighter fit, files added here as “v2”. If you print this version using a flexible filament is necessary, you probably won't be able to insert the charger if you print in PLA/PETG. The previous files remain if you want to print the old version. The photos in blue plastic are the updated TPU version.
—
I wanted to mount this charger on the wall behind the couch, to make the blocked outlets easily accessible and for handy USB charging. All buttons and ports are accessible when mounted. Keyhole slots are sized for #10 screws, I believe (but have not checked) that M5 is roughly equivalent and should work.
As is, the internal dimensions of the bracket are slightly too long so there is a little side-to-side play for the charger in the bracket when mounted, but not enough to bother me. If this one breaks I'll adjust that spacing and upload an updated version. STEP included if it does bother you, or access the source document in OnShape.
I printed in PETG, 0.6mm nozzle, 0.3mm layer height, which was slightly too brittle (small crack when inserting the charger), PLA might be a better choice. Some supports are needed for the “ears”.