Remixed modular stand for electronic microscope
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed to use M5x20mm button head screws.
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 299
- Wydruki
- 3
- Wyświetlenia
- 1215
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I remixed this to use M5x20mm button head screws, as I didn't have any M5x30mm bolts.
For hardware, you'll need 4 x M5x20mm button head screws and 8 nuts. Be sure to tightly screw one nut onto each M5x20mm screw (adding some Lock-Tight is optional, but helps keep the nut at the top of the screw head).
Only the Knobs should be printed with supports.
You'll need to print 2 x Arm1 pieces and only 1 x Arm2.
I've added a smaller base which is printable on a Prusa Mini/Mini+ (but to do so, you'll have to set your Skirt Height to zero in PrusaSlicer).
Note: Arm2 has inbuilt sacrificial bridges which you'll need to clean up by running a screw through the holes before completing your assembly.
Assembly Tip: While screwing together Arm2 & Arm1 pieces; you can temporarily use something like an extra nut, to help push the nuts into place on Arm2 so that the screw can reach it.
2026-05-25: added another knob with extra clearance.