Remixed modular stand for electronic microscope
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed to use M5x20mm button head screws.
- Rating
- 5 / 5
- Likes
- 39
- Downloads
- 299
- Makes
- 3
- Views
- 1,215
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I remixed this to use M5x20mm button head screws, as I didn't have any M5x30mm bolts.
For hardware, you'll need 4 x M5x20mm button head screws and 8 nuts. Be sure to tightly screw one nut onto each M5x20mm screw (adding some Lock-Tight is optional, but helps keep the nut at the top of the screw head).
Only the Knobs should be printed with supports.
You'll need to print 2 x Arm1 pieces and only 1 x Arm2.
I've added a smaller base which is printable on a Prusa Mini/Mini+ (but to do so, you'll have to set your Skirt Height to zero in PrusaSlicer).
Note: Arm2 has inbuilt sacrificial bridges which you'll need to clean up by running a screw through the holes before completing your assembly.
Assembly Tip: While screwing together Arm2 & Arm1 pieces; you can temporarily use something like an extra nut, to help push the nuts into place on Arm2 so that the screw can reach it.
2026-05-25: added another knob with extra clearance.