Speaker cover 140 mm choose your own design - with holders for car speakers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple (car-) speaker cover with design varied by your chosen infill, 140 mm outer diameter
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 272
- Wydruki
- 0
- Wyświetlenia
- 1968
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Hello there!
As I was upgrading my manufacturer sound system in my BMW E46 I noticed the original speaker covers killed a lot of the sound. After some research speaker covers with honeycomb design turned out as a good choice, as its letting flow through more air and thus more soundwaves (so I read at least).
I wanted to be a bit creative and made these DIY choose your own design speaker covers!
They come in 140 mm outer diameter and the holders are made to fit a BMW E46 Compact front speaker system, but should match with any other manufacturer using 140 mm outer diameter for speaker covers.
*****
HOW TO CHOOSE YOUR OWN DESIGN
- Reduce top layers and bottom layers to 0 (find option under print settings)
- Choose infill you like (e.g. honeycomb for good airflow - would not recommend gyroid though, as it could disturb the airflow by design)
- Print in good quality (e.g. 0.1 mm layer height)
You can see some functioning design examples (honeycomb, triangle, hillbert) in the pictures.
*****
PRINT INSTRUCTIONS
Infill: 10-15% depending on your choice
Layer height: 0.10 mm recommended
Material: PLA
No supports or brim needed
*****
ASSEMBLY INSTRUCTIONS + TIPS
I glued mine with Alubutyl (aluminium foil with bitumen-sticky side underneath) into the place of the original speaker covers into the door. Covered all plastic with foam in case of the speaker moving to close to the speaker cover while playing music.
Extra tip: If you have a slightly curvy door interior like I do, you can heat the speaker cover carefully with a hairdryer and press it in place. It will stay curved like that after cooling (unless you reheat it again).
*****
This model is part of my little BMW E46 diy speaker upgrade. You can find the speaker adapter here: https://www.printables.com/model/546797-adapter-for-front-speakers-bmw-e46-3er-series-comp