OP-Z slim case for TEENAGE ENGINEERING "PVC ROLL UP"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This slim case is intended to be used with the official TE pvc roll-up. Therefor it has a friction-close system.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 472
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
I made this slim case to be used with the official TE pvc roll-up.
I have printed other versions available here and there, but most did not fit in the PVC roll-up, only one model did and the problem i found is that the lip for closing is so thin that it breaks pretty fast, and, after two of them i decide to make my own.
Because my intention is to have it inside the roll-up i did not add any closing mechanism, this only relies on friction so if you tilt it you will drop it!
I have included the Fusion 360 file so is easy for you to add a snap lock system if you need it.
For the logo, it is just poured nail varnish in there.
The bottom of the case has a feature to allow the top 4 buttons to slide in without friction.
I printed it all with 6 perimeters to make sure to have a fully rigid model and lighting infill. at .20mm i took me 6 hours to print it all.
If you print it i would love to see a make !!!!
Happy printing!