Lens Collar for Tamron 17-70mm F/2.8
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D Model of a Lens Collar for the Tamron 17-70mm F/2.8
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 64
- Wydruki
- 0
- Wyświetlenia
- 648
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
- 3D Model of a Lens Collar
- Compatible with Tamron 17-70 F2.8
- Useful for centering the weight of the camera on a tripod

I designed this collar for my lens because I regularly use a tripod, and the fiction below the case unbalances the whole thing.
Thanks to this collar, the center of gravity is better placed and I can quickly switch from landscape mode to portrait mode without removing the device.

The design contains a slot for a 3mm Allen key which allows to tighten the M4*12 screw.
During printing, you must insert a square M4 nuts at this location (see prusa slicer screenshot)

During printing, you must insert a square M4 nuts at this location (see prusa slicer screenshot).
I printed mine with a 0.6mm nozzle with a 0.30mm layer height, for infill I often use the gyroid at 15-20% and with 3 layers of perimeters.
4 small notches are placed on the back of the collar to help align the lens.

3 roundings also allow a simpler alignment by putting the name "TAMRON" in their center (see photos if below)


The set can also be attached to a Peak Design backpack clip, but I don't trust PLA enough to use it every day.
