Flipsky dual fsesc4.20 speed controller enclosure

Flipsky dual fsesc 4.2 100amp  speed controller case/enclosure. This case will keep the controller secure and allow all the needed wires to pass thru for connections. The micro USB port is open enough to allow it to be plugged in without removing the lid. 

The openings on the side allow for the hall sensors to pass through

Removable lid for servicing, and 4 mounting points on the bottom for attaching to something secure. 

printed in abs with 40% infill, supports on for anything over 50% overhang, oriented large flat side down for best bed adhesion. 

BOM 

bolts: 

m3x10mm -4 

M2x6mm- 1 

Threaded inserts: 

M2x3mm - 1

M3x6mm - 4 

insert the 5 threaded inserts. place the controller in the box at an angle so the controller mount ends up between the heat sink and controller. theres only one hole on the controller to mount to, thats where the m2 bolt goes. 

route the positive, negative and remote wire ( did not design for uart, fusion file included for those who need to change this) throught the opening in the back. place the 6 motor phase wires in their respective slot. screw the controller down with the one m2 bolt. the rubber mounts on the controller make it a tight fit, i had to take a flat screwdrvier and tuck them down so the lid would sit flush. 

if using hall sensors, install them before the lid. screw the lid on with 4 m3 bolts and its ready to go. 

if changes are made i will add updated files, hope this works for you! i couldnt find a single other file that actually worked right for this controller.