Dyson V7, V8, V10, V11, V15 Vacuum Bag Adapter for 27.4mm Thread
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Added a thread on the end for a 27.4mm thread like the diy vacuum bag here: https://www.thingiverse.com/thing:6107866
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 129
- Wydruki
- 0
- Wyświetlenia
- 1489
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Added a thread on the end to screw onto a 27.4mm thread, like the one on the diy vacuum bag here: https://www.thingiverse.com/thing:6107866. (it is a really good diy vacuum bag by Johnnywatchbox on Thingiverse). If your vacuum starts pulsing as you try to suck the air out of the bag, you can drill a small hole on the side of the adaptor as a “bleed hole”.
Note: Requires supports, recommended to print with thread facing down to minimize the amount of supports needed. This is correct in both of the pre-sliced files.