Large 2 manual color Punisher Medal

Made a medal for my brother as part of his action figure collection.

Punisher model comes from somewhere on the internet as part of another design which I cut up in Fusion 360.
The logo itself was re-meshed and resized, decreased faces and leveled out.
The medal part i then model in F360, including indents for 3 x 6mm x 3mm neodymium magnets and 4x finger grab spots to remove the medal from a surface once attached.
I super glued (ca glue) the magnets in place

Obviously any metal surface can be used for the display or alternatively to wall mount, while model is on its face (magnets up), take a piece of paper and index the magnet locations, transfer the marks to a wall and drill three screws that match the points, check screws are magnetic before hand

Print instructions

When color change occurs, work as quickly as possible but do not rush.

Before printing make sure the white (or secondary color) is ready to be loaded
Check you have a pair of long nose pliers ready
The color change happens at around the 4H mark at layer 37 (7.4 mm)
When new color inserted, purge will happen that is easy to remove, printer waits for your confirmation
Use the pliers to also remove the filament extruded due to heat sink melt quickly before nozzle touches down to start the next layer
The print is 15cm (5.9in) in diameter and 11.2mm (0.44in or 7/16) high
Took 5h24m to complete

Nozzle temp was set to 225C (437F) for layer 1 and 215C (419F) there after
Bed temp was set to 65C (149F) for layer 1 and 60C (140F) thereafter
Layer height 0.2 with single perimeter
Used about 82g of total filament (forgot to weigh before finishing with magnets)