CREALITY K1 MAX RISER VENT CLOSURE
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CREALITY K1 MAX RISER VENT CLOSURE. This device was created to complement Fred Boisselier's riser, Simple Conversion.
- Ocena
- 5 / 5
- Polubienia
- 52
- Pobrania
- 353
- Wydruki
- 1
- Wyświetlenia
- 4274
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I made this part to compliment Fred Boisselier's excellent design for his CREALITY K1 MAX RISER. It allows you to quickly transition from vented to non-vented for higher temperature printing in a matter of seconds.
In model 2.0 I tighten tolerances so that fit and finish is a little bit better.
This model prints on the K1 Max and is a relatively long part at 288 millimeters.
I printed this model with ASA filament because I am not sure what temperatures it will encounter at the top vent of the enclosure.
It prints relatively quickly at 30 minutes per side.
It's not super important but I printed it with 2 walls, 3 bottoms, 3 tops.
The link below is to the riser that this closure compliments.
https://www.printables.com/model/545370-creality-k1-max-riser