CREALITY K1 MAX RISER VENT CLOSURE
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
CREALITY K1 MAX RISER VENT CLOSURE. This device was created to complement Fred Boisselier's riser, Simple Conversion.
- Rating
- 5 / 5
- Likes
- 52
- Downloads
- 353
- Makes
- 1
- Views
- 4,274
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
I made this part to compliment Fred Boisselier's excellent design for his CREALITY K1 MAX RISER. It allows you to quickly transition from vented to non-vented for higher temperature printing in a matter of seconds.
In model 2.0 I tighten tolerances so that fit and finish is a little bit better.
This model prints on the K1 Max and is a relatively long part at 288 millimeters.
I printed this model with ASA filament because I am not sure what temperatures it will encounter at the top vent of the enclosure.
It prints relatively quickly at 30 minutes per side.
It's not super important but I printed it with 2 walls, 3 bottoms, 3 tops.
The link below is to the riser that this closure compliments.
https://www.printables.com/model/545370-creality-k1-max-riser