Handy Joints for 25 x 25 mm Timber (3 types)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Some handy 90 degree joiners for 25 x 25 mm planed timbers. Make square joints without skill or glue, easy to assemble…
- Ocena
- 0 / 5
- Polubienia
- 58
- Pobrania
- 130
- Wydruki
- 0
- Wyświetlenia
- 1058
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Some handy 90 degree joiners for 25 x 25 mm planed timbers.
Make square joints without skill or glue, easy to assemble and disassemble.
They could probably be scaled a little bit to accept other sizes, although I've not tried.
Three types are included:
- Tee25x25 (a T-joint where one piece butts onto another)
This joint requires a clearance hole through the running timber: the screw then taps into the endgrain of the butting timber.
Note this item includes a modelled support to be knocked out prior to use.
- TripleCorner25x25x25 (two pieces butt onto a third, all perpendicular)
This joint has a single screw at a 45 degree angle, which must tighten into an edge of the running timber. Best to file a small flat here and drill a pilot hole (see image).
The joint has grips hidden inside that retain the butting timbers when the screw is tightened.
- Tee25toFace (a T-joint where one piece butts onto a decorative piece and the screws are hidden behind)
The joint has grips hidden inside that retain the butting timber when the screws are tightened.
SAFETY NOTICE:
These joints are ok for light applications but are not as strong as proper joinery and must not be used where failure might cause injury.
FreeCAD source model included
Category: DIY