Handy Joints for 25 x 25 mm Timber (3 types)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Some handy 90 degree joiners for 25 x 25 mm planed timbers. Make square joints without skill or glue, easy to assemble…
- Rating
- 0 / 5
- Likes
- 58
- Downloads
- 130
- Makes
- 0
- Views
- 1,058
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
Some handy 90 degree joiners for 25 x 25 mm planed timbers.
Make square joints without skill or glue, easy to assemble and disassemble.
They could probably be scaled a little bit to accept other sizes, although I've not tried.
Three types are included:
- Tee25x25 (a T-joint where one piece butts onto another)
This joint requires a clearance hole through the running timber: the screw then taps into the endgrain of the butting timber.
Note this item includes a modelled support to be knocked out prior to use.
- TripleCorner25x25x25 (two pieces butt onto a third, all perpendicular)
This joint has a single screw at a 45 degree angle, which must tighten into an edge of the running timber. Best to file a small flat here and drill a pilot hole (see image).
The joint has grips hidden inside that retain the butting timbers when the screw is tightened.
- Tee25toFace (a T-joint where one piece butts onto a decorative piece and the screws are hidden behind)
The joint has grips hidden inside that retain the butting timber when the screws are tightened.
SAFETY NOTICE:
These joints are ok for light applications but are not as strong as proper joinery and must not be used where failure might cause injury.
FreeCAD source model included
Category: DIY