Self watering kit & Tripod for IKEA Muskot 12 cm Plant Pot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses irrigation strings to wick the water up into the soil. Optional tripod will support tall lanky plant.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 472
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
IKEA's Muskot ceramic plant pots are pleasing, affordable, and are made with a handy internal lip a few cm from the bottom - as if someone was going to add a partition there and create a water reservoir in the base...
... Ok, me then.
This design uses irrigation strings to wick the water up into the soil, which is superior method as the soil doesn't get excessively waterlogged.
The "main" part can be used alone, but there is an optional tripod kit which can be used to support a lanky plant.
You will need:
- Muskot 12 cm pot, Ikea part number 50308196
- Irrigation wick / self watering wick, 7 mm diameter. Preferably a synthetic type that's non-rotting.
Improved / Lightweight design:
I have two designs for this purpose, and this is the original one which is perhaps the more robust option. The other, newer, type is much more economical of time and material, though it does lack the tripod option.
Print Settings
Printer Brand:
Creality
Printer:
CR-20
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
30
Filament: _ PLA
Notes:
The main part needs no support if your printer can overhang at least 60 degrees.
The tripod needs a small amount of support in the apex (it's printed upside down). When printing the tripod on a moving bed machine then it's very prone to wobble. Use a close-fitting brim, and really low values for acceleration and jerk. I found out the hard way and junked my first tripod 75% of the way through.
FreeCAD source model included
Category: Outdoor & Garden