CamLock for 32mm hose
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fitting for 32mm hoses, Numatic Henry Hoover and similar. Can add magnet after printing.
- Ocena
- 0 / 5
- Polubienia
- 41
- Pobrania
- 256
- Wydruki
- 0
- Wyświetlenia
- 1074
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Remixed to accept 32mm hoses, Numatic Henry Hoover is probably the most famous brand to use this size hose, so I can use this system on my Hoover wet/dry vacuum that I use in my workshop. Hose screws into the adapter and then normal Camlock fittings can be used.
I also modified the magnet compartment so that you can insert the magnets after printing (so you don't need to watch over the print so you can insert the magnet at the right time or swear . a lot once you realise you've put the magnets in the wrong way round and ruined the print.
The magnets are a tight fit through the hole and need a bit of a push to insert them. Once inserted they will rattle a bit but they have not fallen out (yet) I would recommend using a dab of hot glue, or adhesive of your choice to secure the magnets once fitted.