Ender 3 S1 Pro display mount revisited

DISCLAIMER : After further review and comment, it seems that the cable length of printers is not precise at all and can vary from printer to printer. The 60° model, requires at least 160mm from the plug to the base of the printer where the cable comes out. If you do not have this length, I would suggest printing one of the variants with a less steep mounting mechanism.

This is a complete remake of the original display mount by Minus97 with the added adjustable screwholes by walklife and the extended base by selinuahs.

• Removed the "PRO" branding and shaved the corner off so the piece blends in more and look like an integral part of the printer.
• Reduced the height of the slide-on mechanism to save print time and filament.
• Made 3 extra version with different angles to accomodate for different viewing angles, original one was the 50° version, the printed one on display here is the 60° Extra

I recommend printing sideways (the way the STLs come) with tree supports. i have not personally tested the 50°, 40° and 30° but there is no reason they shouldn't work. The only difference is the angle of the display support.

Print Settings

Printer Brand:

Creality

Printer: 

Ender-3 S1 Pro

Rafts:

No

Supports: 

Yes

Resolution:

0.2mm

Infill: 

20%

Installing the piece.

1. Unplug your display and remove it from the original mounting bracket. Remove the original mounting bracket
2. Unscrew the 2 screws in the corner
3. Slide the piece in place and screw it back in
4. Clip your display on the piece and replug it