1 / 2
Dell Monitor Vesa Adaptor (S2x18, S2x19 monitors)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This print will allow you to use your Dell SE2419HR monitor with a VESA mount based monitor stand.
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 392
- Wydruki
- 0
- Wyświetlenia
- 2631
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 10)Remiksy (0)Kolekcje (31)Powiązane
This print will allow you to use your Dell SE2419HR monitor with a VESA mount based monitor stand.
This will be compatible with any Dell montor that uses the same metal pivot on the stand.
To use:
- Detach base from existing monitor stand - twist screw on bottom of stand
- Detach existing stand from monitor - use a small screw driver to push in the hole at the top of the stand and slide down
- Disassemble the stand - it unclips apart easily then unscrew the two screws in the aluminium core
- Un-screw the steel pivot - its held by 3 M4 screws
- Use the "Bear technique" to capture M4 nuts in the 8 hex holes in the printed part - see https://guides.bear-lab.com/Guide/1.+Preflight+check+and+disassembly/34?lang=en step 2.
- Screw the steel pivot onto the printed part with 3 x M4x18mm cap screws
- mount the monitor :D
Print instructions
Please use 0.2mm layer height for the hole bridges.
I printed with the following settings for strength:
- 6 top and bottom layers
- 15 perimiters
- 50% infill