FTxD Audio Adapter (Case)

3D Print part for FTxD Adapter (see current diagramm) for the FTxD Audio Adapter to use it for digital radio communication. 

The recommend Print material is PETG with a layer high of 0.1mm

For each adapter, you will need two case part (glue it togehter).

This adapter work well with the Yaesu handheld Radio FT1d / FT3D and FT5D (testet).

In combination with an DRA-36 or DRA-50 Board, it works with 9600 BAUD and VARA FM WIDE

Part list for the adapter:

• 1x 3.5mm Audio cable TRRS (4-Pin)
• 1x MiniDIN 6-Pole connector
• 1x PCB breadboard
• 1x 2k and 1x 10k ressistor
• 1x 10uF capacitor
• Jumpercable, shrink tubing, solidering equipment…