PITFT50 w RPi A+ enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
An enclosure for the BTT 5.0" screen V2.1, the one with orientation & brightness buttons at the top. The RPi needs to be mounted on the supplied 25mm spacer or you have issues with the wifi. There's a hole on the back access cover that accepts a 6pin 2.0mm JST inline connector for the accelerometer. This is mean to be a tight fit mine don't even need any glue, but could use hot glue on the inside to secure the wires.
I drilled a hole in the back cover for power that I supply to the header pins. Again here I ended up using a PC power lead for 5V as any smaller cable resulted in brownouts and throttling.
The 4 spacers are screwed on the screen with the screw head in the pocketed side. These allow the back cover to press the screen into the frame.
You'll need 10x M2.5 brass heat-set and a M5x30-35mm bolt and nut for the mount. Mine mounts on the top 20x20 extrusion with 2x M4 bolts and T-nuts.
I printed 3 in ABS