Monopod Tripod Conversion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is designed to add a tripod base to a Dynex DX-SW040 Monopod.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 765
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
This is designed to add a tripod base to a Dynex DX-SW040 Monopod. This design may work with other monopods, but I only own the one monopod so This unit is designed for the Dynex.
The slots for the legs are for 1/2 inches (12.5mm) dowels with a hole to add a screw to lock the dowel in place. I used a 10" Long Dowel (25 cm)
After printing and support removal a 1/2 Inch drill bit was used to clean up the holes so the dowel will fit.
The Monopod is then Attached with zip ties
Print instructions
I printed the original using a 0.6mm Nozzle, but a .04mm Nozzle would work just as well.
I suggest using 4 perimeters to increase strength as this part supports a very top heavy load.