Monopod Tripod Conversion
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is designed to add a tripod base to a Dynex DX-SW040 Monopod.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 66
- Makes
- 0
- Views
- 765
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution
This is designed to add a tripod base to a Dynex DX-SW040 Monopod. This design may work with other monopods, but I only own the one monopod so This unit is designed for the Dynex.
The slots for the legs are for 1/2 inches (12.5mm) dowels with a hole to add a screw to lock the dowel in place. I used a 10" Long Dowel (25 cm)
After printing and support removal a 1/2 Inch drill bit was used to clean up the holes so the dowel will fit.
The Monopod is then Attached with zip ties
Print instructions
I printed the original using a 0.6mm Nozzle, but a .04mm Nozzle would work just as well.
I suggest using 4 perimeters to increase strength as this part supports a very top heavy load.